G3 Boats Angler V172 F 2012 boat specs
G3 Boats
G3 Boats Angler V172 F 2012
2012
View full specs →
VS
G3 Boats Welded Jon - 1756 VBW 2008 boat specs
G3 Boats
G3 Boats Welded Jon - 1756 VBW 2008
2008
View full specs →

G3 Boats Angler V172 F 2012 vs G3 Boats Welded Jon - 1756 VBW 2008: Same Brand, Different Boat

The G3 Boats Angler V172 F 2012 is a deep-V design and the G3 Boats Welded Jon - 1756 VBW 2008 is a modified-V design, so you're likely deciding between two noticeably different on-water experiences. Hull type shapes everything from ride quality and fuel burn to dock handling and resale trajectory.

On paper these two are close siblings in the size department - G3 Boats Angler V172 F 2012 at 17,2 ft versus G3 Boats Welded Jon - 1756 VBW 2008 at 16,0 ft. Weight tells a clearer story for trailering families: the G3 Boats Angler V172 F 2012 tips the scales at 1 440 lbs - 1 015 lbs more than the G3 Boats Welded Jon - 1756 VBW 2008 at 425 lbs. That difference is meaningful if you're working within a half-ton or three-quarter-ton truck's tow rating, especially once you factor in a motor, gear, and fuel.

The power gap is worth calling out. Rated to 115 hp, the G3 Boats Angler V172 F 2012 has a 65-hp advantage over the G3 Boats Welded Jon - 1756 VBW 2008's 50-hp ceiling - enough to notice on acceleration and at cruising speed, particularly with a full passenger load.

Both boats are rated for 5 passengers - a good fit for a family of four or five plus guests. Comfort at capacity is another matter; the longer hull typically means more seat options and better weight distribution.

At this size, power-to-weight ratio matters more than outright horsepower. The G3 Boats Welded Jon - 1756 VBW 2008 comes in at 9 lbs per hp versus 13 lbs per hp for the G3 Boats Angler V172 F 2012. The lower the ratio the more explosive the acceleration - meaningful on a short RIB where bursts of speed, quick planing, and agility in surf or tight waterways define the experience.

Bottom line: Performance buyers should lean toward the G3 Boats Angler V172 F 2012 and its 115-hp ceiling. If fuel economy and quieter running matter more than top-end speed, the G3 Boats Welded Jon - 1756 VBW 2008 with its 50-hp rating is the more economical daily driver.
General Boat Info
MakeG3 Boats
MakeG3 Boats
ModelAngler V172 F
ModelWelded Jon - 1756 VBW
Model Year2012
Model Year2008
Measurements / Dimensions
Beam92 in.
Beam77 in.
Beam - Meters2.34
Beam - Meters1.96
Beam - Inches92
Beam - Inches77
Deadrise13℃
Deadrise3.5℃
Depth - Detail37 in.
Depth - Detail21 in.
Depth - Centimeters93.98
Depth - Centimeters53.34
Depth - Inches37
Depth - Inches21
Weight - Detail1,440 lbs.
Weight - Detail425 lbs.
Weight - kg653.17
Weight - kg192.78
Weight - lbs.1440
Weight - lbs.425
Height [transom]20 in.
Height [transom]20 in.
Length - Feet17.17
Length - Feet16
Length overall - Detail17 ft. 2 in.
Length overall - Detail16 ft. 10 in.
Length overall - Meters5.23
Length overall - Meters5.13
Length overall - Inches206
Length overall - Inches202
Width [transom] - Detailnot available
Width [transom] - Detail56 in.
Length - Inchesnot available
Length - Inches10
Body / Hull
Hull materialAluminum
Hull materialAluminum
Hull thickness0.100 + 0.100 ga. (double plated bow)
Hull thickness0.100 ga.
Hull typeDeep Vee
Hull typeModified Vee
Engine and Drivetrain
Engine makeYamaha
Engine makenot available
Fuel tank capacity - Detail33 gal.
Fuel tank capacity - Detailnot available
Fuel tank capacity - Liters124.92
Fuel tank capacity - Litersnot available
Fuel tank capacity - Gal33
Fuel tank capacity - Galnot available
Fuel typeGas
Fuel typeGas
Drive typeOutboard
Drive typeOutboard
Engine max115 hp
Engine max50T / 60C
Operational Info
StorageLivewells: 14 x 30 in., 15 gal.; 11 x 29 in., 16 gal.
Storagenot available
Maximum capacity1,400 lbs.
Maximum capacity1,170 lbs.
Maximum people5
Maximum people5 / 669 lbs.
Trailer Info
Trailer - Length over all21 ft. 6 in. (deduct 20 in. with Trail Guard tongue removed)
Trailer - Length over allnot available
Trailer - Weight2,410 lbs.
Trailer - Weightnot available
Trailer - Width102 in.
Trailer - Widthnot available

G3 Boats Angler V172 F 2012 vs G3 Boats Welded Jon - 1756 VBW 2008 - Common Questions

Which is the larger boat - the G3 Boats Angler V172 F 2012 or the G3 Boats Welded Jon - 1756 VBW 2008?
The G3 Boats Angler V172 F 2012 is the longer of the two at 17,2 feet overall. The G3 Boats Welded Jon - 1756 VBW 2008 comes in at 16,0 feet, making it roughly 1,2 ft shorter - a meaningful difference in deck room and overall on-water presence.
Which is easier to trailer - the G3 Boats Angler V172 F 2012 or the G3 Boats Welded Jon - 1756 VBW 2008?
For trailering, the G3 Boats Welded Jon - 1756 VBW 2008 has the edge at 425 lbs dry weight versus 1 440 lbs for the G3 Boats Angler V172 F 2012. Add a motor (typically 300–500 lbs for an outboard in this class), gear, and a partial fuel load and the difference grows. Lighter is friendlier on smaller tow vehicles and on fuel economy while hauling.
Which boat can handle a bigger outboard?
The G3 Boats Angler V172 F 2012 is rated to a maximum of 115 hp, giving it the larger power ceiling. The G3 Boats Welded Jon - 1756 VBW 2008 tops out at 50 hp. Keep in mind that maximum ratings are just that - matching the motor to the actual load and usage pattern usually matters more than chasing the ceiling.
How many people can each boat hold?
The G3 Boats Angler V172 F 2012 is Coast Guard rated for 5 passengers, while the G3 Boats Welded Jon - 1756 VBW 2008 is certified for 5. Note that legal capacity and comfortable capacity aren't always the same thing - on a full day out, most experienced boaters aim for about 80% of the rated number to keep things comfortable.
Which boat has the better power-to-weight ratio?
The G3 Boats Welded Jon - 1756 VBW 2008 has a better power-to-weight ratio at 9 lbs per hp compared to 13 lbs per hp for the G3 Boats Angler V172 F 2012. A lower number means quicker acceleration and faster time to plane - the number that actually matters most on short, sporty boats like these.
Which boat is wider, and does it affect trailering?
The G3 Boats Angler V172 F 2012 measures 92" wide, compared to 77" for the G3 Boats Welded Jon - 1756 VBW 2008. The US standard-width towing limit is 8’6" (102") in most states - anything over that may need a wide-load permit. Confirm your specific route requirements with each state's DOT.
Are the G3 Boats Angler V172 F 2012 and G3 Boats Welded Jon - 1756 VBW 2008 from the same manufacturer?
Yes - both the G3 Boats Angler V172 F 2012 and the G3 Boats Welded Jon - 1756 VBW 2008 are built by G3 Boats. That means shared dealer networks, common parts availability, and consistent build quality across the line. The choice between them is essentially a question of how much boat you need, not which brand you trust.